Basic installation diagramI can supply cellular repeater systems for vehicles that allow you to connect your phone wirelessly allowing for multiple cell phones and air-cards to be used simultaneously (4GX shown at right). These complete kits include everything you need to increase the coverage of you mobile cell phone including cig adapter and outside mag mount antenna. Kits for 5-Band 4G networks have replaced the 3G kits. Additional external antennas are available for all possible mobile installations including Truck, RV, and marine applications.


The NEW "Drive4G S" from weBoost is the smallest and easiest way to boost any cell phone's signal in all 3G and 4G bands. It incorporates a remotely located booster and a simple adjustable cradle. This gives your cell phone up to 32 times more input signal when in a vehicle. It also includes a USB charging port on the DC adapter. The package includes everything you need including a DC cig adapter power supply and an streamlined "Shark Fin" mag mount antenna. (CLICK for the spec sheet in .pdf format.)

NOTE: A headset or car kit is required as the phone must stay in this cradle while operating.

Please contact me for exact equipment pricing and your specific installation requirements. Shipping & handling is not included.



Cancer and Reproductive Harm - See:

This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have your provider’s consent. Most wireless providers consent to the use of signal boosters. Some providers may not consent to the use of this device on their network. If you are unsure, contact your provider. You MUST operate this device with approved antennas and cables as specified by the manufacturer. Antennas MUST be installed at least 20 cm (8 inches) from any person. You MUST cease operating this device immediately if requested by the FCC or a licensed wireless service provider.
WARNING. E911 location information may not be provided or may be inaccurate for calls served by using this device. Please note, the four largest carriers, namely, AT&T, T-Mobile, Verizon and Sprint, and more than 90 regional carriers have given a blanket consent to all boosters meeting the new certification standards.

Today's cellular signal boosters are engineered as "demand" or "Linear" type signal boosters as an FCC requirement. If you are within close range of the cell site (i.e. in a moving vehicle a mile away) no addtional power is transmitted by the signal booster until your distance increases and your signal strength starts to drop. The signal booster then starts increasing it's power output to maintain optimum signal up to the booster's maximum output. All the cellular boosters that I offer have built-in overload and oscillation protection.

*Signal range depends on terrain, weather conditions, location of the mobile antenna, location of the cell site, and cellular frequency.

Doug Foote - Owner


Click to return to D & J Enterprises Wireless EquipmentClick to return to Home PageClick to return to my booster home pageClick to go to

Graphics courtesy of weBoosts. Prices subject to change. Updated 3/24/18